TABLE OF DEVICE ADDRESSES
This Device Uses Address Reports as †† Enabled By…
RF Receiver 00 100
∗56 zone programming: input device type entry
AUI 1 (touchscreen) 01
n/a
automatic if AUI enable field *189 enabled for AUI 1
AUI 2 (touchscreen) 02
n/a
automatic if AUI enable field *189 enabled for AUI 2
AUI 3 (touchscreen) 05
n/a
automatic if AUI enable field *189 enabled for AUI 3
AUI 4 (touchscreen) 06
n/a
automatic if AUI enable field *189 enabled for AUI 4
Internal IP/GSM Device 03 103
automatic if installed and enabled in menu mode ∗29
4286 Voice Module 04 104 automatic if phone module access code field *28 enabled
Zone Expanders (4219/4229):
module 1 (for zones 09 - 16)
module 2 (for zones 17 - 24)
module 3 (for zones 25 - 32)
module 4 zones 33 - 40
module 5 zones 41 - 48
07
08
09
10
11
107
108
109
110
111
∗56 zone programming: input device type entry, then:
automatic if zone no. 9-16 entered as AW type or relay assigned
automatic if zone no. 17-24 entered as AW type or relay assigned
automatic if zone no. 25-32 entered as AW type or relay assigned
automatic if zone no. 33-40 entered as AW type or relay assigned
automatic if zone no. 41-48 entered as AW type or relay assigned
Relay Modules (4204):
module 1
module 2
module 3
module 4
12
13
14
15
112
113
114
115
∗79 output device programming: device address prompt:
entered at device address prompt
entered at device address prompt
entered at device address prompt
entered at device address prompt
Keypads:
keypad 1
keypad 2
keypad 3
keypad 4
keypad 5
keypad 6
keypad 7
keypad 8
16
17
18
19
20
21
22
23
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
data field programming as listed below:
always enabled, all sounds enabled.
data field ∗190
data field ∗191
data field ∗192
data field ∗193
data field ∗194
data field ∗195
data field ∗196
5800TM Module 28 n/a automatic
†† Addressable devices are identified by “1” plus the device address when reporting. Enter report code for zone 91 to enable addressable device
reporting (default = reports enabled). See field *199 for addressable device (ECP) 3-digit/2-digit identification keypad display options.
– 23 –
WWW.DIYALARMFORUM.COM
To Next Page
Loading...
