SPYDER MODEL 7 VAV CONTROLLER INSTALLATION INSTRUCTIONS
3 31-00475-01
GENERAL
Trademark Information
• Spyder™ is a trademark of Honeywell International
Inc.
• BACnet® is a registered trademark of ASHRAE Inc.
• Sylk™ is a trademark of Honeywell International Inc.
Product Description
Honeywell’s Spyder Model 7 VAV controller is a
programmable room controller with an integrated
actuator and airflow sensor.
As a freely programmable VAV controller with universal
inputs and outputs, the Spyder Model 7 has
configuration flexibility to achieve a variety of specific
applications. Smart engineering and commissioning
tools with WEBs-N4 workbench and a mobile
application for test and balance make installation cost-
effective.
Spyder Model 7 offers BACnet IP or BACnet MSTP, Sylk™
bus technology, Modbus RTU RS-485, universal inputs
and output (UIO), and solid-state relays.
Controller Part Numbers
Fig. 1 Controller Part Numbers
Table 1 Part Numbers
Part Number Universal IO Solid State Relay
Total
IO
Communication
BLE
Integrated
WEB-VA75IB24NM 7 5 12 IP Yes
WEB-VA75I24NM 7 5 12 IP No
WEB-VA00IB24NM 0 0 0 IP Yes
WEB-VA75MB24NM 7 5 12 MSTP Yes
WEB-VA75M24NM 7 5 12 MSTP No
WEB-VA00MB24NM 0 0 0 MSTP Yes
Table 2 Replacement Part
Part Number Comments
SDPPF500PA Replacement air flow sensor
ANT-REM
Use the remote antenna if the antenna mounted on the controller does not provide
reliable communication due to environmental conditions. The packet contains four
antennas.
To Next Page
Loading...
Need help?
General
