Honeywell X-DCS3000 User Manual

21
4． Time
"Time” is used to set the time parameters of X-DCS3000, as shown below:
 “Synchronization Mode” is to set the parameters of time synchronization for DCS through NTP
protocol. Default setting is off.
 If NTP Server is enabled, DCS will work as a time server, all devices synchronize the
time with it. In other words, all devices’ time would be in conformance with the DCS’s.
 If NTP Client is enabled, DCS automatically synchronizes the time via a time server,
the server IP address and synchronization period should be set.
 “Time Zone Setting” is used to set internal time zone of X-DCS3000. Choose the time zone of
current location, and click “Update” button to change the time zone of X-DCS3000, if “All
Devices” is selected, click “Update” will change the time zone of all devices. If the device time
zone is different from the local time zone, the time and date will be wrong while time
synchronization.
 “Date & Time Setting” is used to view and manually update the device’s date and time. Click
“Get” button to read the device’s date & date. If only click “Update” button, the time and date of
current DCS will changed. If select “All Devices” and click “Update” button, the time and date
of all device, such as X-DCS2000/EN, X-DCS3000, X-NPMS, X-NRI, will be changed.

Honeywell X-DCS3000 Specifications

General

Brand	Honeywell
Model	X-DCS3000
Category	Amplifier
Language	English