6
2 Software Installation
This chapter describes the runtime environment and installation and uninstallation procedures of
the X-618 Config software.
Run Environment
The X-618 Config software sends configuration data to devices within the system through the
network. The computer on which the software is installed must meet the following requirements:
Windows 7, Windows 8 and Windows 10 operating system
(The software is untested in other Windows operating systems.)
1GHz or higher CPU
At least 512MB RAM
At least 1GB of available disk space
10M/100M Ethernet interface
Running at 1024X768 resolution or higher
The software should be granted network access by firewall.
Software Installation
The X-618 Config software is easy to install by following an installation wizard.
1. Put the X-618 system CD into the CD-ROM drive, click X-618 System Commissioning Tool in
the Autorun view or double-click the installation program X-618 Config.exe, and the X-618
Config installation wizard window displays as shown in Figure 1.
Figure 1 X-618 Config Installation Wizard Page
2. Click Next. The License Agreement page is displayed.
3. Select I Agree on the page.
4. Click Next. The information page is displayed.
Read the important information on this page before proceeding to the next step.
To Next Page
Loading...
Need help?
General