Control panel and indicator lights
Programme Selector – Select the required programme
‘Marche Arrêt’ button and indicator – Press to switch on, the indicator will light
‘Départ Différé’ button – Allows the user to delay the start of the drying cycle (see
details of operation page 16)
‘Départ Pause’ – Press ‘Départ Pause’ to commence the selected drying programme
‘Choix Textile’ button – Press to reduce the heat level for delicate items, the indicator
above the button will light up. To change the heat setting the programme must be reset
Low Heat – Indicator light ON High Heat – Indicator light OFF
‘Réservoir Plein’ indicator – lights when the water container is full
‘Entretien Filtre’ indicator – lights when the filter needs cleaning
Display
START – When the dryer is switched on the START indicator will flash, when the
programme starts the START indicator will light up
60' – Indicator lights when there is less than 60 minutes left until completion of the
programme
15' – Indicator lights when there is less than 15 minutes left until completion of the
programme. At this stage of the drying cycle the machine enters the Cool Down phase
STOP – Indicator lights when the programme is finished.
6h – 6 hour start delay (light flashes when in operation)
9h – 9 hour start delay (light flashes when in operation)
11
Controls and indicators
ACRYLICS/
SYNTHETICS
BUTTON
(Choix Textile)
ON/OFF
BUTTON
(Marche
Arrêt)
FILTER CARE INDICATOR
(Entretien Filtre)
EMPTY WATER
INDICATOR
(Réservoir Plein)
PROGRAMME
SELECTOR
START PAUSE
BUTTON
(Départ
Pause)
START DELAY
BUTTON
(Départ
Différé)
COUNTDOWN
DISPLAY
To Next Page
Loading...
