Important: Always switch off and remove the plug
from the electricity supply before cleaning the
condenser.
To maintain the efficiency of the dryer regularly
check that the condenser is clean.
To remove the condenser
1. Gently pull the bottom of the kickplate so
that it unclips from the dryer. The top section
can then be unhinged allowing the kickplate
to be completely removed.
2. Turn the two locking levers anti-clockwise
and pull out the condenser.
3. Pull out the condenser unit.
4. Gently remove any dust or fluff with a cloth,
then wash the unit by holding it under a
running tap turning it so that water flows
between the plates, to remove any dust or
fluff.
5. Refit the condenser ensuring it is in the
correct way (as indicated by the arrow) and
pushed firmly into place. Lock the two levers
by turning them clockwise.
6. Refit the kickplate.
14
Condenser
To Next Page
Loading...
Need help?
General