CONTROLS AND INDICATORS
10 EN
Start/Pause
Button
Filter Care
Indicator
Programme
Display
Programme
Selector
The wool drying cycle of this machine has been approved by The Woolmark
Company for the drying of machine washable wool products provided that the
products are washed and dried according to the instructions on the garment label
and those issued by the manufacturer of this machine. M1524.
In UK, Eire, Hong Kong and India the Woolmark trade mark is a Certification
trade mark.
The Hoover Sensor Dry machine gives many options for drying the laundry to suit all
circumstances. The table on the next page lists the programmes and the function of each
programme.
The sensor may not detect a small load of small articles. For small loads and separate items or pre-
dried fabrics with low moisture content, use the timed programmes. If the sensor does not detect the
item the dryer will only operate for 10 minutes before going into cooldown. If the load is too large or
too wet to tumble dry the dryer will automatically go into cooldown after approximately 3 hours.
depending on the load size
and dryness required, and select high or low heat depending upon the fabric type.
Note:
In
these cases we advise to use a time cycles between 30 and 75minutes
Time Selection
Button
Acrylic Synthetic
Button
Anti-Crease
Button
Delay Start
Button
SELECTING THE PROGRAMME
Programme Selector Select the required programme
Time Selection Button Allows the user to of th
– Allows the user to delay the start of the drying cycle (see details of
Operation ).
Acrylic and Synthetic Button – When pressed the default indicator will fade and will
be illuminated.
Anti- Crease Button
Start/Pause Button – / to pause .
Memo Button user record the program
2 minutes the chosen
program option
Filter Care indicator ights when the filter needs cleaning
Empty Water indicator – L water container is full.
Program Display
Refresh
– .
– change duration e programme selected by
Programme Selector. It can be used only with the selection of: Mix&Dry, Shirts and Time
Programmes.
Delay Start Button
– Allows the user to select a post drying anti-crease cycle.
Press to commence the selected drying programme
– Allows to me by pressing simultaneously the Anti-
Crease and the Acrylic Synthetic buttons for 3 seconds, after duration of
me/ .
– L .
ights when the
– Related indicator lights when a auto programme has been selected.
– The indicator lights up when the programme starts the cool down stage.
Control Panel and Indicator Lights
To Next Page
Loading...
Need help?
General