Hoover aqua vision User Manual

DRAIN HOSE : FITTING INSTRUCTIONS
0 EN8
WARNING! Switch off and remove the
tumble dryer plug from the electricity supply
before carrying out any work.
Fit he s Follows:t Hose a
1.
2.
pipe
left
see the
picture
at the left hand side of
the machine.
3.
4. black
(
)
Tilt the machine
backwards.
The waste water
is situated at the
-hand side of the
machine (
). A grey hose
connects to the bridge
Using
pliers, remove the pipe
retaining clip from the
bridge.
Pull the hose off the
bridge connection.
Attach the
hose from the kit,
using the connector
a n d p i p e c l i p s
supplied , to the hose
removed from the
bridge connection.
5.
6.
does
not kink when pushing
the tumble dryer into
position.
7. Connect the new
drain hose to the waste
8.
Pl a ce t h e t a p
supplied by the kit to
close the remaing
hose.
Once the machine is
in place the feet should
be adjusted to ensure
that the new hose
Water pipe.
Connect to the
m a i n s e l e c t r i c i t y
supply.
To avoid emptying the water container after
each drying cycle, the water can be
discharged directly to a waste water drain pipe
(the same drainage system as household
sinks). Water Bye-Laws prohibit connection to
a surface water drain. The waste water drain
pipe should be located adjacent to the tumble
dryer.
The kit consists of:1 hose and 1 tap.

Hoover aqua vision Specifications

General

Brand	Hoover
Model	aqua vision
Category	Dryer
Language	English