Hoover CWGDH012 - Operation - Standard Use; Using the Carpet Washer; Using Rinse Mode

OPERATION
5
Turn the wash/rinse
dial to rinse. Only
water is released
to remove solution
residue.
Plug into the mains,
press the on/off pedal
to switch on.
Press the recline
pedal and pull the
handle backwards.
Squeeze the trigger to
release solution and
water mix.
For best results apply
water/solution on the
forward stroke and
release the trigger to
pick up water/solution
on the backward
stroke. Follow with
a slow additional
dry stoke without the
trigger pressed for a
dryer finish.
For best results apply
water on the forward
stroke and release
the trigger to pick
up water on the
backward stroke.
Follow with a slow
additional dry stoke
without the trigger
pressed for a
dryer finish.
Using Rinse mode
NOTE: For best cleaning results use slow
straight parallel strokes. Intermittent dry
forward strokes will increase water pick up.
CWGDH012_Hoover MEA_Elite Power Scrub_Gladiator_UG_240818.indd 6 24/08/2018 11:47