Hoover CWGDH012 User Manual

8
MAINTENANCE
Lift the tank release
clip and unhook from
the front of the dirty
water tank.
Empty the dirty water
over the sink. Rinse
the dirty water tank
and lid under water
(40°C max) to remove
dirt/debris.
Use the handle to lift
and remove the dirty
water tank.
For emptying at the
end of a clean, lift
and unhook the latch
on the tank and lift to
remove the lid.
For emptying mid clean,
pull the quick spout
pour cap to open.
Pour the dirty water into
the sink. Always make
sure the spout is fully
closed before refitting to
the washer.
To replace the lid, slide
the tabs on the back of
the lid into the tabs on
the tank and close in a
hinge line manner.
Remove the filter from under the dirty water
tank lid. Wash under water (40°C max) to
remove dirt and debris and allow to dry for
24 hours before refitting.
CAUTION: Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
Emptying and cleaning the dirty water tank
IMPORTANT: Always empty and rinse out clean and dirty water tanks and leave to air dry before
replacing. Do not leave solution stored in the tanks between uses.
IMPORTANT: Not correctly refitting the quick pour spout or dirty water tank lid will result in poor dirty
water pick up.
CWGDH012_Hoover MEA_Elite Power Scrub_Gladiator_UG_240818.indd 9 24/08/2018 11:47

Hoover CWGDH012 Specifications

General

Brand	Hoover
Model	CWGDH012
Category	Vacuum Cleaner
Language	English