Hoover F6210 - Attach Hose and Tools; Hose Connection; Tool Selection and Attachment

7
Continued ➜
Attach the hose
Select tool
Attach tool
Unplug deep cleaner from electrical outlet.
✓ Place handle in upright position.
✓ The hose and tool caddy can be removed from the
cleaner if you desire.
✓ Remove hose from tool caddy.
✓ Open hose door (A) on back of deep cleaner (Fig. 13).
✓ Align hose connector with hose and solution ports (C)
(Fig. 14).
✓ Push hose into port and lock in place.
✓ To remove hose: Squeeze latches (D) on top and bottom
of hose. Remove hose from port (Fig. 15).
✓ Close hose door tightly (inset).
SpinScrub™ hand tool
• Rotating brushes
• Use on carpet to clean
spots, small areas or
stairs
Stair/Upholstery nozzle
• Built-in brush
• Use on upholstery
Unplug deep cleaner from electrical outlet.
✓ Slide tool onto hose. Snap tool over tab (E) on hose (Fig. 18).
✓ To remove tool: Push forward and up on latch (F) (Fig. 19).
Slide tool off hose.
F
E
C
B
D
A
A
A
13
14
15
16
17
18 19