Pull SpinScrub
®
block out. The brushes
can be rinsed under water to remove
debris (Max 100°F). To replace the
SpinScrub
®
block, press rmly and
lock into place. Then replace nozzle by
sliding the two latches inward, locking
the nozzle in place.
1 2 3
Nozzle can be removed
for easy cleaning. Slide
the two nozzle release
latches outwards.
Remove nozzle by tilting
downward then pulling
straight out. Rinse under
running water to clean.
Cleaning the Nozzle and SpinScrub
®
:
Keeping your FloorMate
®
Edge running properly:
Lubrication: The motor is
equipped with bearings which
contain sufcient lubrication
for their lifetime. The addition
of lubricant could cause
damage. Do not add lubricant
to motor.
IMPORTANT: The tanks should
be emptied and cleaned after
each use and before storage.
CAUTION
To reduce risk of injury from
moving parts –
Unplug before servicing.
!!
Any other servicing should be
done by an authorized service
representative. If appliance
is not working as it should,
has been dropped, damaged,
left outdoors, or dropped
into water, take it to a service
center prior to continuing use.
11
To Next Page
Loading...
Need help?
General
