Hoover FloorMate SpinScrub 800

Other manuals for Hoover FloorMate SpinScrub 800

Manual20 pages

Questions and Answers

A
Angela MitchellJul 30, 2025
Why is my Hoover FloorMate SpinScrub 800 Vacuum Cleaner not turning on or has low suction?
- P
  Paul RodriguezJul 30, 2025
  If your Hoover Vacuum Cleaner won’t run or has low suction, first, ensure it's firmly plugged in and check the fuse or breaker. The recovery tank might be full, triggering an automatic shut-off, so empty it. Also, check that the filter and its lid are correctly positioned, the tanks are locked in place, and the nozzle is properly replaced and locked. A dirty filter can cause this issue, so check and clean it if necessary. Finally, ensure the hose door is tightly closed when the hose is not in use.
C
Crystal LopezAug 5, 2025
What to do if my Hoover FloorMate SpinScrub 800 is leaving water puddles behind?
- A
  Amy VazquezAug 5, 2025
  If your Hoover Vacuum Cleaner leaves water puddles behind, try using recommended detergents to reduce excess foaming. Also, ensure the solution tank is correctly installed and remember to empty the recovery tank.
J
Jane SmithAug 11, 2025
Why Hoover FloorMate SpinScrub 800 won’t pick up dirty solution?
- D
  Dustin RobbinsAug 11, 2025
  If your Hoover Vacuum Cleaner won’t pick up dirty solution or pushes a line of dry debris, first check that the Mode selector dial is set for WET PICKUP. Make sure the recovery tank is properly installed and not full. Also, ensure the filter and filter lid are correctly positioned. Check that the Model selector dial is set for DRY VAC. If the debris is too large for the squeegee, tip the nozzle off the floor by pushing down on the handle to pick it up.
K
Katherine LeeAug 16, 2025
How to fix Hoover FloorMate SpinScrub 800 Vacuum Cleaner when cleaning solution won’t dispense?
- B
  bryantkellyAug 16, 2025
  If the cleaning solution won’t dispense from your Hoover Vacuum Cleaner, ensure the solution tank is locked in position and not empty; refill it if needed. Also, the pump may need to be primed, especially when using a tool.
S
Sarah SmithAug 23, 2025
What to do if Hoover FloorMate SpinScrub 800 Vacuum Cleaner brushes won’t rotate?
- T
  Tammy GuzmanAug 23, 2025
  If the brushes on your Hoover Vacuum Cleaner won’t rotate, check that the Mode selector dial is set to WASH. Try resetting the circuit breaker. You can also try turning the cleaner OFF, unplugging it, waiting one minute, plugging it back in, and turning it ON again. If the brushes continue to stall and the breaker trips again, clean the brushes to remove any debris.