Recovery (lower) tank
Automatic shut-off
An automatic suction shut-off is built into the recovery
tank to prevent the tank from overflowing.
When the shut-off activates, the cleaner will not pick up
debris and the sound of the motor will change. The recov-
ery tank is full and must be emptied.
10
D
E
24
25
Slide tank straight into position until latch snaps in
place.
If rubber ring (D) on cap has become dislodged, reposi-
tion it with uneven side against ledge (E) as shown.
Replace cap. Rotate cap clockwise until it locks in place.
Cap must be locked in place for proper performance
and to prevent leaking.
24
25
26
26
To Next Page
Loading...
