Rotate bottom handle support (A) up
to the upright position until a snap is
felt.
Align control rod (B) on upper
handle (C) with slot in bottom
handle support (D).
Push upper handle (C) down until it
is snapped in place.
5
4
2
3
4
2
3
Assemble handle
Continued
➜
C
C
A
D
B
To install brushes, place handle in
upright position. Tilt cleaner back so
that it rests on the floor.
Align post (A) on brush block with hole
(B) on bottom of cleaner. Turn brushes
slightly until post fits easily into hole.
5
Install brushes and nozzle
5
B
A
To Next Page
Loading...
