11
29
Reposition filter.
Replace filter lid. Press down firmly until snapped
in place.
NOTE: The filter, filter lid and tanks must
be
replaced, or the unit will not work properly.
The tank lid contains a washable, reusable filter. Clean
this pleated filter when suction is low or reduced.
Turn cleaner OFF and disconnect from electrical outlet.
Remove recovery tank and lid (Figs. 26 & 27).
Remove filter lid (A), then remove filter (B).
Remove loose debris from filter by tapping the filter or
gently brushing using your hand. The filter may also be
rinsed for additional cleaning. Allow filter to air dry
between uses.
A
B
28
To clean filters
26
C
B
27
How to empty
Turn cleaner off and disconnect from electrical outlet.
Although not necessary for satisfactory performance, it
is recommended that the recovery tank be emptied after
dry vacuuming and before wet operation.
Check the solution tank also. It may need to be refilled
at this time.
To remove tank, press down on release button (B)
and pull tank straight out.
Remove tank lid (C). Empty tank.
26
27
28
29
Continued
➜
To Next Page
Loading...
Need help?
General
