10 11
OTHER
FLOOR EXTENSION TOOL - 14.4V (HH5010WD) ONLY
CARE AND CLEANING (cont)
BATTERY CARE AND DISPOSAL
Wall Mounting
Your Hoover HandiVac comes with a specially designed bracket used to hold the recharging base
so that it may recharge while mounted on wall.
1. To mount the bracket, place it against the wall for the desired position, trace the mounting
holes of the bracket using a sharp pencil, onto the wall or mounting surface. Make sure the
wall bracket is vertically positioned.
2. Drill a diameter hole into each of the marked hole. Insert a plastic anchor into each hole.
screw go into the slot.
5. Insert the second screw through the bracket into the lower anchor, tighten it to secure the
bracket.
NOTE:
NOTE: There are two different wall mount charging bases depending on your model purchased.
such as down small spaces, ceiling cornices, along shelves
or simply down to the floor.
together. Once together, one end will then fit into the Inlet
able to conveniently
store on the special
storage adaptor to
assembly.
your closest agent.
accordance with your local municipal guidelines.
This product contains recyclable materials. Do not dispose of this product as
collection point.
(i)
(ii)
(iii)
To Next Page
Loading...
