Hoover HF4 - Page 8

2 3 4 61
1 2 3 4 5
7 8
6
8
5. CLEANER MAINTENANCE
5.3 FLOOR NOZZLE
5. CLEANER MAINTENANCE
5.4 MINI-POWER NOZZLE*
Thanks to ANTI-TWIST, your Hoover vacuum features an integrated comb which radically reduces hair wrapping
around the brushbar. However, if your cleaner is not picking up eciently your brushbar may need to be cleaned.
1. Ensure your product is switched o.
2. Push the window release slider to the right and fully open the window.
3. To remove the brushbar for cleaning, pull the lever upwards and slide the brushbar out.
4. Remove any excess debris from the brushbar.
5. Check for and remove any large debris from inside the nozzle.
6. Carefully check for and remove any tangled debris from the comb.
7. Re-t the brushbar to the nozzle ensuring the latch is fully in place.
8. Close the nozzle window back into position and push to lock.
IMPORTANT: Ensure the window is fully closed. If the nozzle window is not correctly reassembled,
thenozzleLEDlightswillashonce,thebrushbarstatuslightwillturnredandtheerroriconon
theLEDdisplaywillashred.
* Dependant on your model.
1. Ensure your product is switched o.
2. Remove the mini-power nozzle from your product.
3. To remove the brushbar, unlock the release latch with a coin.
4. Using scissors, remove any tangled bres or debris from the brushbar.
5. Look inside the nozzle and remove any debris.
6. Re-t the brushbar, push and lock the release latch with a coin.
GB