Hoover HF9 - Floor Nozzle Brushbar Cleaning; Mini-Turbo Nozzle Brushbar Care

10
7. CLEANER MAINTENANCE
7.3 FLOOR NOZZLE
7. CLEANER MAINTENANCE
7.4 MINI-TURBO NOZZLE*
1 2 3 4 5
7 8
6
Thanks to ANTI-TWIST, your Hoover vacuum features an integrated comb which radically reduces hair wrapping
around the brushbar. However, if your cleaner is not picking up eciently your brushbar may need to be cleaned.
1. Switch o your product.
2. Unlock the nozzle window sliding the nozzle window release latch and remove.
3. Using the brushbar release latch, remove the brushbar from the nozzle.
4. Remove any excess debris from the brushbar.
5. Check for and remove any large debris from inside the nozzle.
6. Carefully check for and remove any tangled debris from the comb.
7. Ret the brushbar to the nozzle ensuring the latch is fully in place.
8. Ret the nozzle window by locating at the front of the nozzle and closing rmly into location.
IMPORTANT: Ensure the window is fully closed. If the nozzle window is not correctly reassembled,
the nozzle LED lights will ash, the brushbar status light will turn red and error E03 will appear on
the user interface.
*Dependant on your model.
2 3 4 5 61
GB
1. Switch o your product.
2. Remove the mini-turbo nozzle from your product and turn over.
3. Using a coin, open the brushbar release lock and remove the brush bar.
4. Using scissors, remove any tangled bres or debris from the brushbar.
5. Look inside the nozzle and remove any debris.
6. Ret the brushbar into the nozzle and using a coin, lock into position.