Why is there insufficient suction in my Hoover HGM600X Ventilation Hood?
Insufficient suction in your Hoover Ventilation Hood can occur if the distance between the hood and the gas top is too far. To resolve this, refit the cooker hood to the correct distance.
What to do if the light on my Hoover HGM600X Ventilation Hood is not working?
If the lights on your Hoover Ventilation Hood are not working, the cause might be broken or faulty globes. Replace the globes following the instructions provided.
What to do if my Hoover HGM600X Ventilation Hood is leaking oil?
If your Hoover Ventilation Hood is leaking oil, it could be due to: * The one-way valve and outlet not being tightly sealed. Take down the one-way valve and seal with sealant. * Leakage from the connection of the chimney and cover. Take the chimney down and seal it.
What to do if the light is on but the motor does not work on my Hoover Ventilation Hood?
If the light is on but the motor isn't working on your Hoover Ventilation Hood, it might be because the fan switch is turned off. Select a fan switch position to solve this.
What to do if my Hoover HGM600X is inclining?
If your Hoover Ventilation Hood is inclining, the fixing screw might not be tight enough. Tighten the hanging screw to make it horizontal.
Why light and motor do not work on my Hoover Ventilation Hood?
If neither the light nor the motor is working on your Hoover Ventilation Hood, check the following: * House fuses might be blown. Reset or replace the fuses. * The power cord might be loose or disconnected. Refit the cord to the power outlet and switch the power outlet on.
General| Type | Chimney |
|---|---|
| Width | 60 cm |
| Extraction Rate | 600 m³/h |
| Number of Speeds | 3 |
| Lighting | LED |
| Noise Level | 62 dB |
| Colour | Stainless Steel |
| Number of Motors | 1 |
| Control Type | Push Button |
| Material | Stainless Steel |
| Filter Type | Aluminium |
To Next Page
