Hoover HMIH 2T1047-80 User Manual (English)

Questions and Answers:

S
Seth WilliamsAug 10, 2025
Why Hoover Dishwasher doesn't start?
- N
  Nicholas FitzpatrickAug 10, 2025
  Your Hoover Dishwasher might not start due to several reasons: the door isn't closed properly, a delay start is set, the mains plug isn't connected, or a fuse in the house circuit is damaged. Make sure the appliance door is fully closed, check the delay start settings, connect the mains plug securely, and replace the fuse if necessary. Also, refill rinse aid and softener salt until full, pressing the button for 3 seconds after each refill.
S
Shannon MartinezAug 16, 2025
Why Hoover HMIH 2T1047-80 won't start?
- J
  Jeremiah RobertsAug 17, 2025
  If your Hoover Dishwasher doesn't start, stops mid-cycle, or the indicator light is on, check these: * Ensure the appliance door is fully closed. If the delay start is set, refer to the displayed time. * Verify the mains plug is securely connected. * Inspect the house circuit fuse and replace it if damaged. * Check the rinse aid dispenser and refill it until full, then press the button for 3 seconds. * Ensure the softener salt tank is full with specific salt, then press the button for 3 seconds after refilling.
D
Diana SantanaAug 28, 2025
What to do if Hoover Dishwasher displays error codes?
- D
  Daniel GuzmanAug 28, 2025
  If your Hoover Dishwasher shows an error code, here's what to check: * Ensure the water tap is open and the water inlet hose isn't kinked or bent. If you solve the error, switch off the appliance and restart the program. Also, make sure that the position of the hose is correct. * Check for clogs in the water inlet and ensure adequate water pressure. Clean the filter at the inlet hose connections at the tap and the rear of the appliance. Contact your local water authority to check water flow from tap. * If the anti-flood device is activated due to water leakages: close the water tap, disconnect the appliance from the power supply, and contact service.
M
Mrs. Margaret RoseSep 4, 2025
How to prevent water spots on Hoover HMIH 2T1047-80?
- R
  Rodney SchroederSep 4, 2025
  If you notice dry water drop stains on glasses and dishes after using your Hoover Dishwasher, consider the following: * Increase the released quantity of rinse aid. * Replace the rinse aid or Multitab cleaning product if it's too old. * If the dishes are wet after a cycle, slightly open the dishwasher door (about 100°) to aid the drying process. * Refill the rinse aid dispenser and reset the rinse aid indicator. * Replace the rinse aid or Multitab cleaning product if it's too old.

Hoover HMIH 2T1047-80 Specifications

General

Appliance placement	Freestanding
Product size	Full size (60 cm)
Number of place settings	10
Noise level	47 dB
Number of washing programs	5
Drying system	Condensation
Delayed start timer	Yes
Delay start (max)	24 hours
Half Load Option	Yes
Washing programs	Eco, Intensive, Quick
Width	448 mm
Depth	55 cm