What to do if the spin function does not work on Hoover HNT6414 Washer?
If the spin function on your Hoover Washer isn't working, it might be because the washing machine hasn't finished draining the water yet; allow a few minutes for it to drain completely. Alternatively, the “Spin Exclusion” option might be activated; disable this option to enable the spin function.
How to fix Hoover HNT6414 when the water does not drain?
If your Hoover Washer isn't draining water, the filter might be clogged. Check the filter and clean it if necessary. Also, inspect the outlet pipe to ensure it isn't bent, and straighten it if needed.
Why the high-speed spin does not work on my Hoover HNT6414 Washer?
The high-speed spin may not work on your Hoover Washer if the wash load isn't evenly distributed within the drum. To fix this, distribute the wash load evenly in the drum.
Why is my Hoover Washer vibrating so much during the spin cycle?
Strong vibrations during the spin cycle of your Hoover Washer can occur if the washing machine isn't correctly leveled. To resolve this, adjust the feet of the appliance. Another cause could be that the anchoring device for transport hasn't been removed; make sure to remove the transport support. Also, ensure that the wash load is evenly distributed within the drum.
Why no programme works on my Hoover Washer?
If your Hoover Washer isn't working, start by ensuring it's properly plugged in and that the general switch is activated. Also, check if there is electricity and that the fuses in the electrical installation are intact. Finally, make sure the door is fully closed.
Important precautions for cleaning and maintenance tasks.
Guidance on unpacking, component removal, and water hookups.
General advice on keeping the machine clean.
Step-by-step guide for cleaning the machine's filter.
Guide to selecting programmes, pre-wash, rinse, and spin options.
General| Appliance placement | Freestanding |
|---|---|
| Colour | White |
| Built-in display | Yes |
| Drum material | Stainless steel |
| Rated capacity | 6 kg |
| Spin speed | 1400 RPM |
| Spin-drying class | B |
| Washing class | A |
| Delayed start timer | Yes |
| Loading type | Front load |
| Delay start (max) | 24 hours |
| Width | 600 mm |
| Height | 850 mm |
| Dimensions (H x W x D) | 850 x 600 x 520 mm |
To Next Page