Warning: To reduce the risk of personal injury, unplug the carpet washer before performing
maintenance/troubleshooting checks.
Why won’t my carpet washer turn on?
• The plug may not be fully pushed into the electrical socket.
• Check the fuse in the plug if this needs replacing, always replace with a 13amp fuse
Why won’t the solution/clean water dispense?
• Make sure the clean water tank is fitted securely
• The clean water tank valve may be stuck, hold the clean water tank over the sink and press the valve
underneath to release
Why won’t my carpet washer pick up?
• The float in the dirty water tank may have been activated. Empty the dirty water tank wait for the float to
settle before re-starting your carpet washer
• Check the dual spin power brushes for blockages and clear
• The dirty water tank may not be fitted correctly, also make sure the lid is pushed down securely
• Check the nozzle for blockages and clear.
• Check the nozzle is correctly fitted, go to ‘Maintenance’.
Why won’t the brushes spin?
• The brushes will only spin when the carpet washer is reclined.
• Check the dual spin power brushes for blockages and clear.
• The belt may be broken, go to ‘Maintenance’.
12
FAQS
To Next Page
Loading...
