Service & Help
If you have queries or concerns about using your Hoover, please visit www.hoover.ae
Technical Specification
Voltage: 220-240V ~50Hz
Wattage: 1000W
Cord length: 8m (approx)
Weight: 8.9 kg (approx)
Subject to technical change without notice.
Consumables
Ultra+ Carpet Cleaning Solution 1.5L
Part Number: 1-9-134076-00
EEC Statement of Compliance
Manufacturer/EEC importer: Hoover, hereby on our own responsibility, declare that the
HW86-DPM-S series is manufactured in compliance with the following Directives:
Safety: 2006/95/EC Low Voltage Directive
EMC: 2004/108/EC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice.
Warning: To reduce the risk of personal injury, unplug the carpet washer before performing
maintenance/troubleshooting checks.
Why won’t my carpet washer turn on?
• The plug may not be fully pushed into the electrical socket.
• Check the fuse in the plug if this needs replacing, always replace with a 13amp fuse
Why won’t the solution/clean water dispense?
• Make sure the clean water tank is fitted securely
• The clean water tank valve may be stuck, hold the clean water tank over the sink and press the valve
underneath to release
Why won’t my carpet washer pick up?
• The float in the dirty water tank may have been activated. Empty the dirty water tank wait for the float to
settle before re-starting your carpet washer
• Check the dual spin power brushes for blockages and clear
• The dirty water tank may not be fitted correctly, also make sure the lid is pushed down securely
• Check the nozzle for blockages and clear.
• Check the nozzle is correctly fitted, go to ‘Maintenance’.
Why won’t the brushes spin?
• The brushes will only spin when the carpet washer is reclined.
• Check the dual spin power brushes for blockages and clear.
• The belt may be broken, go to ‘Maintenance’.
To Next Page
Loading...
