MAINTENANCE
8
IMPORTANT: Your dirty water tank is fitted with a float. When the dirty water tank is full, or the floor
head is not in contact with the carpet the float will shut off the suction on the carpet washer. You will
be able to hear if this has happened as the motor noise on the machine will increase. Once the float is
activated, empty the dirty water tank if full. If the dirty water tank is not full then turn off your machine at
the power switch and wait for the float to settle.
CAUTION: Always unplug the carpet washer before performing any
maintenance/troubleshooting checks.
Lift to remove dirty
water tank lid. Empty
dirty water over the
sink. Rinse dirty water
tank and lid under
water to remove debris.
Press dirty water tank
release latch, pull to
remove.
Clean the filter screen
located at the back of
the dirty water tank.
Lift dirty water tank clips up and outward
to release.
To re-fit, tilt clean
water/solution tank
and line up to carpet
washer. Push back until
it clicks into place.
Emptying and cleaning the dirty water tank
To Next Page
Loading...
