3. Open the lid located on the top of the container and
empty the water.
4. Refit the lid and slide the water container back into
position. PUSH FIRMLY INTO PLACE.
5. Refit the kickplate by engaging the hinges at the top and
‘snapping’ the lower clips into place.
Important: Always switch off and remove the plug from the
electricity supply before cleaning the condenser.
To maintain the efficiency of the dryer regularly check that the
condenser is clean.
To remove the condenser
1. Remove the kickplate (see page 13).
2. Turn the two locking levers anti-clockwise and pull out
the condenser.
3. Pull out the condenser unit.
4. Gently remove any dust or fluff with a cloth, then wash
the unit by holding it under a running tap turning it so
that water flows between the plates, to remove any dust
or fluff.
5. Refit the condenser ensuring it is in the correct way (as
indicated by the arrow) and pushed firmly into place. Lock
the two levers by turning them clockwise.
6. Refit the kickplate.
14
Condenser
To Next Page
Loading...
