Quest
TM
remote control
12
2X - Quest will
complete 2 cleaning
cycles including one
charging cycle.
Directional buttons. (
) activates smart fence
where your invisible wall is
placed. After Quest
™
cleans
the current room (approx
30 min), smart fence will
deactivate and allows
Quest
™
to pass through. To
manually deactivate smart
fence at any time,
press the key again.
Pull the tab to
activate your
Remote control.
Quiet Mode:
(
Low
) - to enable/
disable Quiet Mode.
IMPORTANT:
During Quiet operation
mode, suction rate and
speed of your Quest
™
maybe lower.
( ) - Turn on/off
(
) - Start Cleaning
NOTE: Quest
™
automatically returns to the docking station and docks itself
when its running low on battery power. If it fails to dock after a few attempts, you
may manually position it correctly on the docking station. After fully charged (4.5-
5.5) hours, Quest™ turns all the LEDs off and is ready to use.
To Next Page
Loading...
Need help?
General
