_J2d)
Insert screw and secure handle to cleaner
body.
Attach nozzle
Line up raised rib (M) on front of nozzle
with raised rib just above opening on
Gleaner. Push nozzle securely into
cleaner.
Push nozzle cord into clip (N) at back of
cleaner.
Insert nozzle plug into receptacle (O) on
back of cleaner. Push plug firmly to ensure
it is fully inserted.
Button cord strap (P) onto receptacle.
Attach hose and
tool
Facing the back of the cleaner, position
hose connector (O) into holder (R) on
right side of Gleaner body making sure
latch (S) is inside holder.
Loop hose over hose hook (T) and posi-
tion tool into holder (U) on other side of
cleaner body.
Operate cleaner only at voltage speci-
fied on data plate located on back of
cleaner motor housing.
Polarized plug
To reduce the risk of electric shock, this
product has a polarized plug (one blade
is wider than the other). This plug will fit in
a polarized outlet only one way. If the
plug does not fit in the outlet, reverse the
plug. If it still does not fit, contact a quali-
fied electrician to install the proper outlet.
Do not change the plug in any way.
Plug cord into electrical outlet. Your
cleaner in now ready to operate.
i
I
O
ON-OFF switch
Press switch down to turn OFF (O);
press switch toward handle to turn
ON (I).
m
B
Powered nozzle
The powered nozzle has a Brush Roll
Switch (A) which allows you to turn the
brush roll ON or OFF during quick pick-
ups and light Gleaning on hard surface
floors, carpet and rugs.
The brush roll is visible through the Brush
View Window (B).
ii
Carpet/Rug cleaning
With cleaner turned ON, push Brush Roll
Switch (A) on nozzle to ON/CARPET.
Hard surface floor
cleaning
With cleaner turned ON, push Switch (A)
to OFF/HARD FLOOR.
To Next Page
Loading...
