EasyManua.ls Logo

Hoover S2610 - Cleaning and Maintenance; Dirt Cup Cleaning and Emptying; Using the Hose and Tool Attachment; Carrying Handle Feature

Hoover S2610
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0leaning under low
furniture
Your cleaner has been designed to do an
effective job Gleaning under low furniture
and in hard to reach areas. Lower handle
toward the floor and proceed with back
and forth motion.
Hose and tool
Turn cleaner OFF before attaching or
removing hose.
The hose and tool may be used for Glean-
ing in tight spaces, corners and along
edges in such places as dresser drawers,
upholstered furniture, stairs and base-
boards.
Lay Gleaner on floor with backside up.
Remove hose connector and tool from
holder.
Lift hose door (C) upward.
Insert hose connector (D) until it snaps
into position. Suction will automatically
be diverted to the hose when cleaner is
turned on.
To remove hose, press latch (E) on hose
connector and pull outward.
Note: Hose must be removed from
hose door when cleaning carpet and
floors to insure proper cleaning.
After using the hose and tool, place them
back in the holder as for storing.
Carrying handle
For your convenience a carrying handle
(F)is provided to assist in moving the
cleaner and when cleaning stairs.
III
Storing cleaner
When Gleaner is not in use, wrap cord
around cord hooks and place hose and
tool in holder as shown.
For your convenience, cleaner may be
hung on a hook from opening at top of
handle.
Familiarize yourself with these home main-
teRence tasks as proper use and care of
your cleaner will ensure continued clean-
ing effectiveness.
Dirt cup
The dirt and debris picked up by the
cleaner is deposited into the dirt cup. It
is recommended that the dirt cup be
emptied after each use.
When empty, the cup can be Gleaned with
a damp cloth or rinsed with water. Be
sure cup is dry before reusing.
The filter and cyclonic Gone assembly,
located inside the cup, prevents small
particles from entering the motor cRam-
ber. Uoweve h very fine materials, such
as face powder, cornstarch and fire-
place ashes, picked up in large quanti-
ties can seal the filter and cause a 10ss
of suction. When using the cleaner for
this type of dust, empty cup often.
m
How to empty dirt cup
Disconnect cleaner from electrical
outlet.
Lift latch (A) at bottom of cup to release
cup.
m
Grasp cup and pull forward to remove it
from the cleelnel.
Continued
5

Related product manuals