12
Using Your SmartWash Carpet Cleaner
When you nish cleaning
but further drying is
required, press the DRY
ONLY BUTTON. The Dry Only
mode will extract remaining
water from your carpet.
Continue in this mode
until little water is visibly
passing through the Nozzle.
6
5
4
7
Slowly pull backward. The
cleaner will automatically
dry your carpets by
extracting the water and
cleaning solution.
Slowly move forward. The
cleaner will automatically
dispense the optimal
amount of water and
cleaning solution.
For best results, HOOVER®
recommends rinsing the
carpet with clean water
only. This will remove
residual carpet cleaning
solution from your carpets.
To rinse with clean water
only, remove the Solution
Tank and then repeat steps
4 through 6.
CLEANING FLUID
SEE THE HOOVER’S SOLUTIONS
GUIDE insert.
To Next Page
Loading...
