EasyManua.ls Logo

Hoover SMARTWASH+ - User Manual

Hoover SMARTWASH+
22 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
USER MANUAL
FACSMCW20A
IMPORTANT: Read all instructions carefully before assembly and use.
This product is intended for Household use only.
©2020 Techtronic Industries Australia Pty Ltd. All Rights Reserved.
31 Gilby Road, Mount Waverley, VIC 3149. Australia
IPX4
Double
Insulated
This product
meets applicable
regulatory
requirements
Indoor
Use
Only
Read
Instructions

Table of Contents

Questions and Answers

  • A
    Angie ReedAug 12, 2025
    Why won't my Hoover SMARTWASH+ Vacuum Cleaner turn on?
    • T
      Tami GonzalezAug 13, 2025
      Your Hoover Vacuum Cleaner might not be running due to several reasons: it might not be firmly plugged in, so ensure it is. There may be no voltage in the wall plug, so check the fuse or breaker in your home. A fuse might be blown or the breaker tripped, so replace the fuse or reset the breaker. The fuse in the cleaner itself might be blown, in which case you should take it to a service center. Finally, the On/Off pedal may not be depressed, so ensure you press it properly.
  • M
    Melissa SmithAug 16, 2025
    What to do if my Hoover SMARTWASH+ has low suction?
    • S
      Shawn KaneAug 16, 2025
      Low suction in your Hoover Vacuum Cleaner can be caused by several factors. The Dirty Water Tank might be full, triggering an automatic shut-off; empty it. There could be a blockage in the tool on the end of the hose; remove the tool and clear any blockages. Ensure the Dirty Water Lid is securely in place. The Dirty Water Tank Debris Filter could be clogged. Also, check for blockages in the Nozzle. Make sure the Dirty Water Tank is properly secured and that the Dirty Water Nozzle is correctly attached. Finally, a blockage in the hose itself could be the culprit; try dropping a coin through or clearing it with a broom handle.
  • D
    Dr. Jeffrey RodriguezAug 20, 2025
    What to do if my Hoover SMARTWASH+ Vacuum Cleaner hose nozzle stops spraying liquid?
    • L
      Linda GarciaAug 20, 2025
      If your Hoover Vacuum Cleaner's hose nozzle stops spraying liquid, the Clean Water Tank or Detergent Container may be empty; turn off the cleaner and refill them. Also, check for a loose connection to the solution port on the foot of the cleaner and ensure it's securely connected to the body.
  • R
    Richard SanfordAug 25, 2025
    Why is my Hoover Vacuum Cleaner leaking water?
    • T
      Tina BrownAug 25, 2025
      Water leaking from your Hoover Carpet Cleaner can be due to a few reasons. The Clean Water Tank, Solution Tank, or Dirty Water Tank may not be firmly in place; ensure each tank is secure. Also, the carpet cleaner may drip residual moisture after use; allow the cleaner and brushes to dry before storing it.
  • C
    christopherleeAug 27, 2025
    Why won't clean water dispense from my Hoover SMARTWASH+ Vacuum Cleaner?
    • A
      ayersvictoriaAug 27, 2025
      If clean water isn't dispensing from your Hoover Vacuum Cleaner, it could be that the Clean Water Tank or Solution Tank is not firmly in place; make sure the tank is securely locked. Alternatively, the Clean Water Tank or Solution Tank might be empty; refill the container according to the cleaning instructions.
  • W
    William GibsonAug 31, 2025
    Why won’t the brushes rotate during floor cleaning with my Hoover Vacuum Cleaner?
    • S
      Shelby CastilloAug 31, 2025
      If the brushes on your Hoover Vacuum Cleaner won’t rotate during floor cleaning, the brush roll stall protection may have activated; turn the unit off and back on, then inspect and clean for jams. Also, brushes will not rotate when the unit is in the upright position; step on the handle release to start cleaning.
  • T
    torresdavidSep 4, 2025
    How to fix accessory tool that will not spray after filling the Clean Water Tank or Solution Tank on my Hoover Vacuum Cleaner?
    • A
      april30Sep 4, 2025
      If the accessory tool on your Hoover Vacuum Cleaner won't spray after filling the tanks, air might be trapped in the hose and pump. Turn on the cleaner. If the hose still doesn't spray, prime the pump by lowering the hose down to the floor and hold the trigger for up to one minute.
  • T
    Theresa MartinSep 8, 2025
    Why won't solution dispense from my Hoover Vacuum Cleaner?
    • M
      mserranoSep 8, 2025
      Solution won't dispense from your Hoover Vacuum Cleaner if the cleaner is not moving in a forward direction. You must move the machine forward to properly dispense water and solution.

Summary

Important Safety Instructions

Product Precautions and Grounding

Damage Prevention Precautions

Guidelines to prevent damage to the product and flooring during use and storage.

Grounding Instructions

Essential electrical grounding requirements for safe operation of the appliance.

Product Components and Setup

Whats in the Box?

Lists all items included in the product packaging.

Getting to Know Your HOOVER SmartWash

Identifies and labels the various parts and features of the carpet cleaner.

Operation and Usage Guide

Tools & Accessories Overview

Details the function and usage of included tools and accessories.

Before You Begin Cleaning: Pretreating

Guides on preparing the carpet and area before cleaning, including pretreating.

Getting Started With Your SmartWash Carpet

Step-by-step instructions for assembling the cleaner and filling the water tanks.

Using Your SmartWash Carpet Cleaner

Comprehensive guide on operating the carpet cleaner for washing, drying, and rinsing.

Cleaning Carpeted Stairs and Upholstery

Specific techniques for cleaning stairs and upholstery with the carpet cleaner.

Maintenance Procedures

How to Empty

Instructions for emptying the dirty water tank and cleaning the filter.

How to Remove and Clean Nozzle

Steps for removing, cleaning, and reinstalling the cleaner's nozzle.

How to Change and Clean Brushes

Procedures for removing, cleaning, and replacing the brush rolls.

Accessories and Hose Operations

How to Attach Hose

Instructions for connecting and disconnecting the accessory hose.

How to Remove Hose

Steps for safely removing the accessory hose from the cleaner.

How to Attach Tools

Instructions for connecting various cleaning tools to the accessory hose.

Troubleshooting and Support

Troubleshooting Common Issues

Lists common problems, their causes, and potential solutions for the carpet cleaner.

Notices

Important operational notes and warnings not covered elsewhere.

Need Help?

Contact information and advice for customer support and warranty assistance.

Hoover SMARTWASH+ Specifications

General IconGeneral
BrandHoover
ModelSMARTWASH+
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals