Hoover SMARTWASH+ - How to Change and Clean Brushes

16
WARNING
Risk of personal injury – Brush roll may suddenly
restart – unplug before cleaning or servicing.
! !
To prevent possible
leaking, remove
Clean Water Tank,
Dirty Water Tank and
Solution Tank.
Grab Side A and pull
up to remove. Repeat
on the other brush.
At an angle, align side
B on the brush to the
drive gear.
1
3
1
2 4
2
With handle in upright
position, follow
“Nozzle: How to
Remove and Clean”
instructions (page 15).
The brushes can be
cleaned under running
water.
Press Tab A down
until brush snaps in
place.
STORAGE
Before storing: Empty Clean Water Tank and let air dry. Replace
on cleaner. Empty Dirty Water Tank, clean lter of dirt/debris, rinse
tank and lid thoroughly with clean water and let air dry. Empty
Solution Tank, rinse tank with clean water and let air dry.
Allow brushes and underside of carpet cleaner to air dry
thoroughly before storing carpet cleaner on a carpeted or
wood surface.
Maintenance
How to Change and Clean Brushes
HOW TO REMOVE HOW TO REPLACE
A
A
B
LUBRICATION
The motor and brush rolls are equipped with bearings which
contain sufcient lubrication for their lifetime.
The addition of lubricant could cause damage. Do not add
lubricant to motor bearings or brush rolls.
CORD STORAGE
Wrap the power cord around the cord hooks for convenient
storage. Attach the plug end to the cord.