19
Read “Before you Begin Cleaning”
instruction on page 9.
Attached hose as instructed (page
18).
Place handle in upright position.
FlexForce™ PowerBrushes will not
rotate while handle is in upright
position.
Fill Clean Water Tank according to
instructions.
Fill Solution Tank with HOOVER®
solution according to instructions on
page 10.
Attach tool to end of hose.
Dry hands and plug cleaner into a
properly grounded outlet.
1
3
5
7
2
4
6
8
9
10
11
12
Pre-spray the area by holding the
tool about one inch above the
carpet and push it forward while
pressing the trigger.
Slightly press the tool it into
area cleaning. Press the trigger
and pull the tool slowly over the
carpet. Release trigger at end
of stroke.
Lift tool, and position it against
Nozzle. Pull tool slowly over
carpet without pressing trigger.
Slightly overlap strokes to help
prevent streaking.
It is best to alternate wet and
dry strokes as described in
9
11
Tools and Accessories
Cleaning Carpeted Stairs and Upholstery
Tips
To avoid saturating carpet, do not
use more than 4 wet strokes over
any one area. Always end with dry
strokes.
If additional cleaning is necessary,
wait until the carpet is completely
dry before using the tool again.
Empty Dirty Water Tank when the
motor sound beccomes higher
pitched and there is a loss of
suction. You will also see the oat
rise and shut off suction at the
same time.
When nished cleaning, follow
“After Cleaning” and “After Using
Tool” instructions.
CAUTION
Use extra care when cleaning on stairs. To avoid personal injury or damage, and to prevent the cleaner from falling, always place
cleaner at the bottom of stairs or on oor. Do not place cleaner on stairs or furniture, as it may result in injury or damage.
To Next Page
Loading...
