Precautions & Assembly
7.
Assembling the Vacuum Cleaner
1. Connect the hose to the cleaner at the hose inlet.
2. Insert the telescopic rod into the combination floor tool.
3. Fit the other end of the telescopic rod to the handle.
4. Press the On/Off button to turn the cleaner on.
5. Suction can be varied by sliding the suction control slider.
IMPORTANT! Always remove the plug from the power socket before fitting or
removing accessories! Do not exceed the blue mark when pulling out the cord.
The yellow mark shows the ideal cable length.
To Next Page
Loading...
