7.
WARNING! Always switch off the cleaner before fitting
or removing accessories.
Assembly
1. During connection, please place the powerhead on the floor and
insert into the main body of the unit, in the direction shown in
figure 1.
2. Lift the handle upwards and lock into place until it clicks. If you need
to fold the handlee for storage, use the handle lock to release and
fold handle.
3. Insert the handvac air inlet to the fixed hole of the main body then
push the handle into place. It will click into place.
Warnings
Assembly of powerhead
To Next Page
Loading...
Need help?
General
