Hoover WH21000 User Manual

10
Refreshing carpets
WARNING: To reduce the risk of
personal injury - Unplug the steam cleaner
when assembling the accessories.
WARNING: Do not clean over floor
electrical outlets. Do not use steam cleaner
or press the Steam Trigger without water in
the Main Water Tank.
IMPORTANT: When using on carpets,
always ensure the multi-surface Microfiber
Pad is properly attached to the Floor Head.
• The steam cleaner and accessories get very
hot during use, always allow them to cool
down before handling.
3.
Move the steam cleaner
slowly backwards and
forwards across the floor.
Squeeze and release
trigger as required.
4.
To release the carpet
glider, place foot on
clip and push down. Lift
steam cleaner to unhook
and remove.
Using tile and grout scrub brush and SteamStream
™
WARNING: Do not clean over floor
electrical outlets. Do not use steam cleaner
or press the Steam Trigger without water in
the Main Water Tank.
1.
Place foot on outer floor
head and gently pull
away steam cleaner to
release the tile and grout
scrub brush.
2.
Move steam cleaner back
and forth across the floor,
getting into corners and
awkward places.
3.
To engage SteamStream™ from the front
nozzle, press the SteamStream™ button
to activate, and squeeze the trigger to
release steam. Press the SteamStream™
button to turn OFF (0=OFF).
1.
Place the microfiber pad
on the floor white side
facing up. Place floor
head onto pad making
sure the entire pad covers
the floor head.
2.
With microfiber pad attached,
hook the steam cleaner into
the front of the carpet glider
and push to clip into place.
Carpet glider should only be
used when refreshing carpets.

Hoover WH21000 Specifications

General

Brand	Hoover
Model	WH21000
Category	Steam Cleaner
Language	English