8
1.
Place the microfiber pad
on the floor white side
facing up. Place floor
head onto pad making
sure the entire pad covers
the floor head
2.
.Plug into an outlet and
Push On/Off switch to
turn ON (I=ON). The blue
light will illuminate
to show power on. The
green light will illuminate
to show the steam mop
is ready to use.
3.
Adjust the steam dial to
desired setting.
4.
Utilize the Supplemental
Water Tank by turning
the dial to "LARGE AREA"
when cleaning large
spaces and turn the dial
to "SMALL AREA" for quick
cleaning.
Operation
WARNING: To reduce the risk of
personal injury - Unplug the steam cleaner
when assembling the accessories.
IMPORTANT: Please refer to floor
manufacturer’s care recommendations
before use and test the steam cleaner on a
discrete area of flooring to begin with.
NOTE: The steam cleaner is equipped
with a thermostat and a thermal cut out. If
for any reason the steam cleaner overheats
it will switch o. If this happens turn o and
unplug the steam cleaner, allow to cool for a
least 2 to 4 hours and re-start.
To Next Page
Loading...
Need help?
General
