HOPPER JOEY DISH User Manual

12
Programming Remote to
Control Another Device
There are three ways that you can program your
DISH Network remote to control another device,
such as a TV, DVD, BD, VCR, audio receiver, or
amplier:
• Scanning the Remote Database
• Entering a Code
• Learning Codes
Use Scanning the Remote Database if you don’t
know the device code. The receiver scans the
database of codes for the particular device and
tries each code. When you nd one that works, you
save that code.
Use Entering a Code when you know the device
code.
Use Learning Codes when either your device isn’t
listed under Lookup or when you have scanned the
database and none of the codes worked.
Typically, the TV mode button is programmed to a
TV; the DVD mode button is programmed to a DVD,
BD, or VCR; and the AUX button to a DVD, BD,
VCR, audio receiver, or ampliier. However, each
of the Mode buttons are programmable to whatever
device you select.
Each of these procedures is discussed in the
following pages.

HOPPER JOEY DISH Specifications

General

Brand	HOPPER JOEY
Model	DISH
Category	Remote Control
Language	English