3
EN
Table of Contents
Introduction
Length
25.8 in (655mm)
Height
9.3 in (235mm)
Main Rotor Diameter
28.4 in (721mm)
Tail Rotor Diameter
5.6 in (142mm)
Gross Weight
26.9 oz (762 g)
Motor
420H Brushless outrunner, 3800Kv (installed)
ESC
35-amp brushless (installed)
Battery
3S 11.1V 2200mAh 30C Li-Po (included with RTF)
Charger
DC Li-Po Balancing Charger (included with RTF)
Transmitter
Spektrum DX6i 6-channel Computer Radio with AA
Batteries (included with RTF)
Receiver
Spektrum AR6115e Microlite 6 Channel Receiver
(installed)
Swash Servos
DS76 (installed)
Tail Servo
DS76T (installed)
Gyro
G210 MEMS Micro Heading Lock (installed)
Blade 450 3D Specifications
Components
To register your product online, visit www.bladehelis.com
Charging the Flight Battery ...........................................................................4
Low Voltage Cutoff (LVC) ...............................................................................4
Throttle Hold ................................................................................................. 4
Transmitter and Receiver Binding ..................................................................5
Installing the Flight Battery ...........................................................................5
Gyro Test ......................................................................................................6
Motor Control Test .........................................................................................6
Flying the Blade 450 3D ................................................................................7
Gyro Gain Adjustment ...................................................................................7
Post-Flight Inspections and Maintenance ......................................................7
Throttle Curve and Pitch Curve......................................................................8
Intermediate ................................................................................................. 8
Advanced......................................................................................................8
FCC Information ............................................................................................8
Warranty and Repair Policy ...........................................................................9
Warranty and Service Contact Information ....................................................9
Customer Service Information .....................................................................10
Compliance Information for the European Union ..........................................10
The Blade® 450 3D will give intermediate to advanced heli pilots an outdoor ready-to-fly experience like no other. It comes out of the box 100% factory built and
equipped with state-of-the-art features like brushless power, digital servos, a MEMS heading lock gyro, CCPM control and symmetrical Blades. Its new and
improved digital cyclic and tail servos provide crisper, cleaner response for added precision and stability while the new heading lock gyro provides more control
over the tail for additional control and confidence. And because it’s flight tested at the factory, no pre-flight setup is required. The Blade 450 3D is ready for
everything from smooth hovering to 3D aerobatic flying as soon as you finish charging the battery included with the RTF, or bind to your DSM transmitter if
purchasing the BNF Basic. The 450 3D’s new aggressive body and trim scheme make this Blade one hot heli.
To Next Page
Need help?
General
