Horizon Hobby HobbyZone AeroScout S 2 1.1m Trainer User Manual (English)

Questions and Answers:

C
Colton WilsonAug 18, 2025
What to do if my Horizon Hobby Toy aircraft does not operate?
- K
  Kayla WellsAug 18, 2025
  If your Horizon Hobby Toy aircraft doesn't operate, several factors could be at play. First, ensure the transmitter and receiver are linked by re-binding the system according to the manual's instructions. Check that the transmitter's AA batteries are correctly installed and not depleted; replace them if needed. Confirm all electrical connectors are securely connected. Ensure the flight battery is fully charged. Finally, a crash might have damaged the radio inside the fuselage, requiring replacement of the fuselage or receiver.
J
John JamesAug 20, 2025
Why does my Horizon Hobby Toy aircraft keep turning in one direction?
- J
  Jack WebbAug 21, 2025
  If your Horizon Hobby Toy aircraft consistently turns in one direction, the rudder or aileron trim might not be correctly adjusted. Try adjusting the stick trims. After landing, manually adjust the aileron and/or rudder linkages to eliminate the need for transmitter trim. Also, ensure that the aileron positions are correctly set.
K
Kyle RobertsAug 23, 2025
What to do if my Horizon Hobby HobbyZone AeroScout S 2 1.1m Trainer aircraft will not bind (during binding) to the transmitter?
- D
  David HenryAug 23, 2025
  If your Horizon Hobby Toy aircraft won't bind to the transmitter, first, move the powered transmitter a few feet away from the aircraft and then disconnect and reconnect the battery to the aircraft. Ensure that the aircraft and transmitter are not near any large metal objects, wireless sources, or other transmitters; relocate if necessary and try binding again. Check that the bind plug is correctly installed and bind the aircraft to the transmitter. Finally, verify that both the flight battery and transmitter battery have sufficient charge, replacing or recharging them if needed.
J
James ClarkAug 26, 2025
What to do if my Horizon Hobby Toy aircraft is difficult to control?
- D
  Dana TaylorAug 26, 2025
  If your Horizon Hobby Toy aircraft is proving difficult to control, start by checking for any damage to the wing or tail, and replace any damaged parts. Inspect the propeller for damage, and if found, land immediately to replace it. Also, verify that the center of gravity is correctly positioned; if it's behind the recommended location, shift the battery forward and do not fly until the correct center of gravity is achieved.
T
tamara98Aug 27, 2025
What to do if my Horizon Hobby HobbyZone AeroScout S 2 1.1m Trainer aircraft will not connect (after binding) to the transmitter?
- A
  ashley20Aug 27, 2025
  If your Horizon Hobby Toy aircraft won't connect to the transmitter after binding, first, move the powered transmitter a few feet away from the aircraft, then disconnect and reconnect the battery to the aircraft. Make sure that the aircraft and transmitter are not near any large metal objects, wireless sources, or other transmitters; if they are, move to another location. Ensure that the bind plug is not left installed; rebind the transmitter to the aircraft and remove the bind plug before cycling power. Check that both the aircraft and transmitter batteries are sufficiently charged, replacing or recharging them if necessary. Lastly, the transmitter may have been bound to a different model, so bind the aircraft to the transmitter.
T
Tammie WaltersAug 30, 2025
Why does my Horizon Hobby HobbyZone AeroScout S 2 1.1m Trainer Toy aircraft nose rise steeply at half throttle?
- S
  stonetracieAug 30, 2025
  If your Horizon Hobby Toy aircraft's nose rises steeply at half throttle, it could be due to several reasons. The wind might be too gusty or strong, so consider postponing the flight until the wind calms down. The elevator might be trimmed 'up' too much; if you need to adjust the trim more than 4 clicks, adjust the push rod length. Also, ensure that the battery is installed in the correct position, moving it forward approximately 1/2 inch if necessary.
L
Linda SmithSep 1, 2025
Why does my Horizon Hobby HobbyZone AeroScout S 2 1.1m Trainer Toy aircraft vibrate?
- E
  Edward RobertsSep 1, 2025
  If your Horizon Hobby Toy aircraft is vibrating, the propeller, spinner, or motor may be damaged. Try tightening or replacing these parts.
T
Timothy GonzalesSep 3, 2025
Why is the flight time too short for my Horizon Hobby HobbyZone AeroScout S 2 1.1m Trainer aircraft?
- C
  coxjoanneSep 4, 2025
  If the flight time of your Horizon Hobby Toy aircraft is too short, ensure the battery is fully charged by recharging it. Avoid flying at full throttle for the entire flight; instead, fly just above half throttle to increase flying time. Fast wind speed might be unsuitable for safe flight, so fly on a calmer day. A damaged propeller can also reduce flight time, so replace it if necessary.
J
Julie ChenSep 6, 2025
How to fix rudder, ailerons, or elevator that do not move freely on my Horizon Hobby HobbyZone AeroScout S 2 1.1m Trainer aircraft?
- Z
  Zachary IbarraSep 6, 2025
  If the rudder, ailerons, or elevator on your Horizon Hobby Toy aircraft do not move freely, it may be due to damaged or blocked push rods or hinges. Repair any damage or remove any blockage.
J
John LittleSep 8, 2025
Why won't my Horizon Hobby Toy aircraft climb?
- D
  Douglas ThompsonSep 8, 2025
  If your Horizon Hobby Toy aircraft will not climb, make sure the battery is fully charged before flying. The elevator may be trimmed 'down', so adjust the elevator trim 'up'. Also, check if the propeller is damaged or installed incorrectly; if so, land immediately and replace or correctly install the propeller.