Horizont User manual, 1970 year
– 4 –
. Insert the end of the film into the take-
slit and, rotating the take-
up spool with your finger,
slightly tighten the film.
9. Return the film rewind knob to its initial position and fix it by turning in the arrow direction.
10. Set the shutter by turning the shutter setting knob as far as it will go.
Press the release button.
Tighten up the film on the take-up spool.
11. Close the back cover.
If the camera is loaded correctly, the film rewind knob will spin. If not, check the camera for correct
loading. It is possible that the film end left the take-up spool slit. In this case, reload the camera.
. Set the exposure counter at the red line. To do this
lift the winding knob up to the stop and, turning the lower
disk, align the red line with the index on the winding
knob.
13. Wind the film till figure 1 appears in the window
of the exposure counter.
. Not to forget the sensibility of the film loaded in
your camera, set its value in the window of film speed
reminder.
4. Taking the Picture
To Next Page
Loading...