1 About These Instructions ..................................... 21
1.1 Further applicable documents ................................ 21
1.2 Warnings used ........................................................ 21
1.3 Definitions used ...................................................... 21
1.4 Symbols used ......................................................... 21
1.5 Abbreviations used ................................................. 22
2
Safety Instructions ......................................... 22
2.1 Intended use ........................................................... 22
2.2 Non-intended use ................................................... 22
2.3 Fitter qualification ................................................... 22
2.4 Safety instructions for fitting, maintenance,
repairs and disassembly of the door system .......... 22
2.5 Safety instructions for fitting ................................... 22
2.6 Safety instructions for initial start-up
and for operation .................................................... 23
2.7 Safety instructions for using
the hand transmitter................................................ 23
2.8 Approved safety equipment.................................... 23
2.9 Safety instructions for inspection
and maintenance .................................................... 23
3 Fitting ..................................................................... 23
3.1 Preparation for Installation ...................................... 23
3.2 Electrical connection .............................................. 24
3.3 Connecting additional components to the
circuit board ............................................................ 24
3.4 Connecting additional components
to the motor connection circuit board .................... 25
4 Putting the Control Into Service .......................... 25
4.1 Preparations ............................................................ 25
4.2 Factory reset .......................................................... 26
4.3 Setting additional functions via the DIL switches ... 26
5 Radio ...................................................................... 27
5.1 Hand transmitter HSM 4 ......................................... 27
5.2 Extending the remote control with additional
hand transmitters HS 1, HS 4, HSM 4 or HSE 2 .... 28
5.3 Integrated radio receiver ......................................... 28
5.4 Programming the hand transmitter buttons
on an integrated radio receiver ............................... 29
5.5 Deleting all data in an integrated radio receiver ..... 29
5.6 Excerpt from the declaration of conformity
for the receiver ........................................................ 29
6 Operation ............................................................... 29
6.1 Instructing users ..................................................... 29
6.2 Function check ....................................................... 29
6.3 Normal operation .................................................... 30
6.4 Partial opening ........................................................ 30
6.5 Operator light .......................................................... 30
6.6 Mains failure bridging using an emergency
battery HNA 18 ...................................................... 30
Contents
A Articles supplied ..................................................... 2
B Tools needed for fitting .......................................... 2
Dissemination as well as duplication of this document and the
use and communication of its content are prohibited unless
explicitly permitted. Non-compliance will result in damage
compensation obligations. All rights reserved in the event of
patent, utility model or design model registration. Subject to
changes.
6.7 Operation after the decoupling mechanism
(mechanical release) has been actuated ................ 30
7 Operator light ........................................................ 30
7.1 Operator light .......................................................... 30
7.2 Messages when mains voltage is on ...................... 31
7.3 Maintenance display ............................................... 31
8 Operation, error and warning messages ............ 31
9 Inspection and Maintenance ............................... 32
9.1 Replacement bulb ................................................... 32
10 Optional accessories ............................................ 32
11 Dismantling and Disposal .................................... 32
12 Warranty Conditions ............................................. 32
12.1 Performance ........................................................... 33
13 Excerpt from the Declaration
of Incorporation .................................................... 33
14 Technical data ....................................................... 33
15 Overview of DIL switch functions........................ 34
16 Overview of errors and troubleshooting ............. 35
Illustrated section ..................................... 123
20
TR10A073-B RE / 02.2012
ENGLISH
To Next Page
Loading...