Safety instructions for initial start-up 2.6
and for operation
WARNING
Danger of injury during door travel
See the warning in section
▶
4.1, section 5 and section 6
CAUTION
Danger of door falling
See warning in section
▶
4.1
Danger of crushing in the side guide
See warning in section
▶
4.1 and section 6
Danger of injuries due to the hot lamp
See warning in section
▶
4.1 and section 9.1
Safety instructions for using 2.7
the hand transmitter
WARNING
Danger of injury during door travel
See warning in section
▶
5.1
CAUTION
Danger of injuries due to unintended door travel
See warning in section
▶
5.1
Approved safety equipment2.8
Safety relevant functions or components of the control, such
as the force limit, external photocells, when installed, have
been designed and approved in accordance with category 2,
PL “c” of EN ISO 13849-1:2008.
WARNING
Danger of injuries due to faulty safety equipment
See warning in section
▶
4.2
Safety instructions for inspection 2.9
and maintenance
WARNING
Danger of injury due to unexpected door travel
See warning in section
▶
9
Fitting3
ATTENTION:
IMPORTANT INSTRUCTIONS FOR SAFE INSTALLATION.
OBSERVE ALL INSTRUCTIONS, INCORRECT FITTING
COULD RESULT IN SERIOUS INJURY.
3.1 Preparation for Installation
DANGER
Compensating springs are under high tension
Serious injuries may occur while adjusting or loosening
the compensating springs!
For your own safety, only have a specialist conduct
▶
work on the door compensating springs. The same
applies to all maintenance and repair work!
Never try to replace, adjust, repair or reposition the
▶
compensating springs for the counterbalance of the
door or the spring mountings yourself.
In addition, check the entire door system (joints, door
▶
bearings, cables, springs and fastenings) for wear and
possible damage.
Check for the presence of rust, corrosion and cracks.
▶
A malfunction in the door system or an incorrectly aligned
door can cause serious injuries!
Do not use the door system if repair or adjustment
▶
work must be conducted!
Only operate the roller garage door operator if you
▶
have full view of the door's area of travel during the
entire time the door is in motion.
Before driving in or out, always check that the roller
▶
garage door has fully opened. You may only drive or
pass through the roller garage door when the door
is at a standstill.
Before installing the operator and in the interests of personal
safety, make sure that any necessary maintenance and repair
work to the door system are carried out by a qualified
specialist.
Only correct fitting and maintenance by a specialist company
or a competent person in compliance with the instructions
ensures safe and flawless operation of the system.
The specialist carrying out the work must ensure that
installation is conducted in compliance with the prevailing
occupational safety rules and regulations and those governing
the operation of electrical equipment. The relevant national
directives must be observed. Potential hazards are avoided
by construction and fitting according to our guidelines.
All safety and protective functions must be checked
▶
monthly to ensure that they are in working order.
Any malfunctions and / or defects must be remedied
immediately.
ATTENTION
Damage caused by dirt
When drilling, dust and chippings can lead to malfunctions.
Cover the operator during drilling work.
▶
Before fitting and operating the door system:
CAUTION
Danger of crushing in the side guides
Do not reach into the side guides with your fingers during
door run, as this can cause crushing.
Do not reach into the side guides during door travel
▶
TR10A073-B RE / 02.2012 23
ENGLISH
To Next Page
Loading...