To Next PageTo Next Page
Need help?Do you have a question about the Hornady LOCK-N-LOAD and is the answer not in the manual?
General| Manufacturer | Hornady |
|---|---|
| Model | Lock-N-Load AP |
| Operation | Manual |
| Type | Reloading Press |
| Features | Quick change die system |
| Die Compatibility | Standard 7/8"-14 dies |
| Primer System | Automatic |
| Warranty | Limited Lifetime Warranty |
List of all parts for the Lock-N-Load® AP™ Reloading Press.
Introduction to the press, tools needed, and safety warnings.
Instructions for securely mounting the AP Press to a workbench.
Guidance on installing and removing the AP Press shell plate.
Steps for assembling the automatic primer feed system.
List of parts for the Lock-N-Load® Powder Measure.
Safety and operational precautions for the powder measure.
Components list for the Case Activated Powder Drop.
Procedures for assembling the Case Activated Powder Drop.
Parts list for the AP™ Case Feeder.
Introduction to the case feeder and mounting the tubing.
Installing the case slide and cam wire.
Mounting the feed tube bracket and installing the V-block.
List of parts for the AP™ Pistol Bullet Feeder.
Introduction to the pistol bullet feeder.
Instructions for bench mounting the bullet feeder.
Initial setup procedures for the bullet feed hopper.
Explanation of the AP Press mechanism and reloading sequence.
Guidance on installing the AP Press shell plate.
Instructions for loading primers into the primer tube.
Steps for case prep, primer seating, and powder drop.
Overview of components for caliber changes: shell plate, dies, primers.
Steps for changing primer slide and punch assembly.
Changing powder measure components like inserts, rotors, and sleeves.
Changing case feeder components for different cartridges.
Instructions for replacing and adjusting the V-Block.
Adjusting pistol bullet feeder components for different bullet types.
Procedures for setting up the bullet feed die.
Common problems and solutions for AP Press operation.
Solutions for shell plate timing and rotation issues.
Reference chart for rifle dies and reloading components.
Reference chart for pistol dies and reloading components.
Template for drilling mounting holes for press and feeder.
