KBW/CR Version R1.0 140323 Take me back to Top…. Page 65 of 130
Working out CV values to enable specific sounds…
From the tables above it is possible to calculate the Decimal value required to be entered in a CV to select specific sounds for play.
1, Select the sound you desire
2, Ignore the Bit# column and look at the number shown in the ADD column. Remember this number.
Keep repeating this process until you have a string of numbers that represent the sounds you wish to play during AFC operation.
ADD these numbers together and programme the CV with the result… that’s it.
Disabling a sound from AFC control.
If you wish to remove a sound, simply subtract its corresponding number which appears in the ADD column.
Note for advanced users… the Bit# column shows the bit position for each sound represented in the list… some controllers require this information... consult your controller manual.
Notes re Selecting sounds for AFC control… Please read this.
It is possible to select any of the 18 sound functions for inclusion in the AFC play sequence. (i.e., F2-F20.) However, not all of these spot sounds are necessarily suitable or
desirable for AFC control… e.g., loop sounds? The suitability of a particular spot sound may depend on whether the locomotive is “stationary” or “running.”
For advice re selecting which spot sounds maybe suitable for play when the locomotive is either stationary or running etc please consult your decoder function list leaflet.
The leaflet is specific to the sound set of that decoder.
While it is possible to select loops etc for AFC play, when played they will be interrupted as the next sound is selected for play.
Selection of sounds is not limited, but the above notes will help you select suitable sounds for each AFC mode.
Please check decoder function list documentation for more information re whistles and horns and other sounds…
To Next Page
Loading...
Need help?
General
