Hornby HM7000-8 User Manual

KBW/CR Version R1.0 140323 Take me back to Top…. Page 68 of 130
CV159… Volume of F0 (re Sound Only Projects… Does Not Apply to Locomotive decoders.)
This CV only applies to specialised sound only type decoders i.e, it, does not apply to locomotive control decoders. Note that “sound only decoders” use the same basic
hardware as the locomotive types. Hence this entry to the CV table. This is to allow for further development of the Vent Van concept as seen with early TTS releases. It is
possible that the new decoder could be the basis of future development. This CV was added the HM7000 sound decoder series to allow for this development in the future.
Default Value
Range
Comments
50
0-255
Volume F0 only… Special Case for sound only decoders
CV160... ELECTRIC motors volume
ELECTRIC locomotives only
Default Value
Range
Comments
50
0-255
Volume Locomotive motors ELECTRIC only. Also applies to stationary sounds.
CV161… Steam/Diesel engine volume on Acceleration and Deceleration
Steam and Diesel locomotives only
Default Value
Range
Comments
50
0-255
Volume Locomotive motors Diesel/Steam. Also applies to stationary sounds.

Hornby HM7000-8 Specifications

General

Brand	Hornby
Model	HM7000-8
Category	Media Converter
Language	English