horsch Maestro CX - Page 90

8 | Drill unit
90 60013444 • 01 • 01/2021 • en
Check the coulter pressure and the seed placement with every change to the press
rollers.
Any change of setting can affect the seed placement.
Variants
Select between different press rollers depending on the type of soil:
• Rubber press rollers – narrow version
• Rubber press rollers – wide version
• Rubber (narrow) / finger press wheel
• Rubber (narrow) / spike press wheel
• Profiled press rollers
Rubber press rollers –
narrow version
• Width 25 mm
• suitable for maize, sunflower, soy, (sorghum, sugar beets)
• recommended on medium soils
The width of the gap between the rollers can be adjusted.
Rubber press rollers, narrow version
1 Standard setting for maize, sunflower, soy
2 Setting for sugar beet and sorghum (small seed)
3 Spacer bushing
Always adjust the same gap width on all press rollers.
1. Loosen the screw, take off press roller and spacer bushing (c).
2. Assemble spacer bushing and press roller in reverse order.
3. Tighten the screws with 200 Nm.
Rubber press rollers –
wide version
• Width 50 mm
• Gap 7mm
• suitable for sorghum and sugar beets
• recommended on very light soils