6
Setting the Programme Times
The programme times have been preset as shown in the chart below.
If any changes are required to the
programme times please complete
the operation as described in the
owchart left.
1st ON 1st OFF 2nd ON 2nd OFF 3rd ON 3rd OFF
Mon - Fri 6.30AM 8.30AM 12.00PM 12.00PM 4.30PM 10.30PM
Sat/Sun 7.30AM 10.30AM 12.00PM 12.00PM 5.00PM 11.00PM
Upon programming
completion
Press the green ‘SET’
button
Press the green ‘SET’
button
Close cover
DEFAULT TIME SETTINGS - AM/PM
Press the green ‘SET’
button
Use the ‘+’ and ‘-’
buttons to select
required day
Repeat process for
the 2nd and 3rd time
settings
Use the ‘+’ and ‘-’
buttons to adjust
required ON time
Use the ‘+’ and ‘-‘
buttons to select the
Heating or Hot Water
Channel to be adjusted
Once a day has been
programmed this
information can be
used to programme
other days of the week
To use the copy
facility, first select
the day required for
programming by using
the ‘+’ and ‘-‘ buttons.
When the required day
is on the screen press
the ‘copy’ button to
enable the changes to
be made – repeat as
necessary
Open cover
Press ‘ENTER’
Press ‘ENTER’
Press ‘ENTER’
Press ‘ENTER’
To independently
programme the
remaining days follow
the flowchart above
Adjust OFF time
SAMPLE DISPLAYS
SET HEATING 1
SET HEATING 2
SET HEATING 3
SET WATER
SET HOLIDAY MODE
SET DEFAULTS
SET HEATING 1
SET HEATING 1
FOR
WEDNESDAYS
SETTING
HEATING 1 - WEDNESDAYS
ON 06.30 ON 12.00 ON 16.30
OFF 08.30 OFF 12.00 OFF 22.30
PERIOD 1 PERIOD 2 PERIOD 3
ON 06.30
ADJUSTING SETTINGS
When carrying out any alterations to the
programmed times and settings the programmer
will return to its normal run mode in 1 minute if
no adjustments are made in that time.
Enter the required on and off times
Select the day to set
Select the required channel setting
To Next Page
Loading...
Need help?
General
