Horton HT650 - Page 9

To Next Page

To Previous Page

Steps 1-2

Fan

Drive

Fan

Supplied nuts and lockwashers

Step 5

3. Make the air line connections between the Solenoid Valve and

the Fan Drive.

4. Check for proper air pressure to the Fan Drive. This measurement

should always be taken at the Fan Drive air inlet port.

NOTE

To assure maximum horsepower carrying capacity of the Fan

Drive and to prevent damage to the Fan Drive, there must be a

minimum pressure of 90 to 120 psi [6.2 to 8.3 bar] to the Fan Drive

upon engagement.

5. AfxtheWARNINGstickertoahighlyvisibleareaoftheengine

compartment.