26 27
Cleaning the vehicle
Secure storage of the vehicle
Please park the vehicle in a at, solid, well-ventilated and dry
place. Please avoid exposing the vehicle to weather conditions
such as sunlight, rain/snow, etc. for long periods of time. If you
park the vehicle for a longer period of time, please note the addi-
tional information in the service/maintenance booklet.
Please mix tap water and neutral detergent to clean the
vehicle. After cleaning the vehicle, wipe the surface with a
soft cloth.
Do not clean your vehicle directly with a strong jet of water
(e.g., high-pressure cleaner, etc.), which can cause faults or
damage to mechanical and electrical components due to
moisture.
Please refer to the more detailed information and instruc-
tions in the separate service and maintenance manual.
Error codes / control unit
Error codes and description
Flashing
frequency
of the LEDs
Overvoltage protection
Undervoltage protection
Motor overvoltage protection
Protection against blocking
HALL sensor protection
Power supply error
Phase line faults
Self-test error
Overheating protection of the
control unit
Twist throttle signal error
Motor overheating protection
Position error of the twist
throttle after starting the
vehicle
General error of the control
unit
The battery voltage is too
high.
The battery voltage is too low.
One or more phases of the
motor are short-circuited.
The time of the stalling motor
exceeds the value set in the
control unit.
Error on the HALL sensor of
the motor or the wiring
After the self-test, the power
supply to the control unit is
faulty.
One or more phases of the
motor are disconnected.
Failed self-test of the control
unit
The temperature of the con-
trol unit is too high.
The input signal of the twist
throttle is faulty.
The motor temperature is too
high.
When the vehicle is switched
on, the twist throttle is not
in the starting position (zero
position).
The control unit is in an error
state.
1
2
3
4
5
6
7
10
11
12
13
14
15
To Next Page
